aut.vn Đồng hồ đo đa năng Omron K3HB-RNB-A-DRT1 AC100-240

Power supply voltage : 100 to 240 VAC 50/60 Hz
Input type : Pulse (NPN/voltage pulse input)
Digits : 5 digit (-19999 to 99999)
Number of event input : 5 point
Power supply voltage : 100 to 240 VAC 50/60 Hz
Allowable power supply voltage range : 85 to 110% of the power supply voltage
Power consumption : 18 VA max. (at maximum load)
External power supply : 12 VDC ±10% 80 mA
Input type : Pulse (NPN/voltage pulse input)
Output type : Transfer output: DeviceNet
Pulse measurement input : Function : F1: Rpm/circumferenitial speed/Instantaneous flowrate
F2: Absolute raito
F3: Error raito
F4: Accuracy
F5: Flow rate ratio
F6: Passing time
Contact input (dry contact input) : 30 Hz max. ON/OFF pulse width of 15 ms min.
No contact voltage pulse : 50 kHz max. ON/OFF pulse width of 9 µs min.
Voltage level : ON voltage: 4.5 to 30 V, OFF voltage: -30 to 2 V, input impedance: 10 kΩ
Open collector : 50 kHz max. ON/OFF pulse width of 9 µs min.
Measurement range : F1 to F6: 0.5 mHz to 50 kHz
(for voltage pulse/open collector sensors)
Accuracy : F1, F6: ±0.006% rdg ±1 digit
F2 to F5: ±0.02% rdg ±1 digit
(23±5 ℃, for voltage pulse/open collector sensors)
Event input : Number of input : 5 point
Input method : NO-Voltage contact/NPN open collector
Event name : Startup compensation timer input
Hold input
Reset input
Connection method : Terminal blocks
Contact : ON: 1 kΩ max.
OFF: 100 kΩ min.
No-contact : ON residual voltage: 2 V max.
OFF leakage current: 4 mA max.
Maximum applied voltage: 30 V max.DC
Leakage current: 0.1 mA max.
Display : Display method : Negative LCD (backlit LED) 7-segment digital display
Digits : 5 digit (-19999 to 99999)
Character height : PV: 14.2 mm (green/red)
SV: 4.9 mm (green)
Insulation resistance : 20 MΩ min. (at 500 VDC)
Dielectric strength : Between the entire external terminal and case: 2,300 VAC 1 min
Noise immunity : ±1,500 V at power supply terminals in normal or common mode (waveform with 1-ns rising edge and pulse width of 1 µs/100 ns)
Vibration resistance : Malfunction: 10 to 55 Hz, Acceleration: 50 m/s2, 5 min 10 sweeps each in X, Y, and Z directions
Shock resistance : Malfunction: 150 m/s2, 3 times each in 3 axes 6 directions
Degree of protection : Front: NEMA4X for indoor use (equivalent to IP66)
Case rear: IP20
Terminals: IP00 + finger protection (VDE0106/100)
Memory protection : EE-PROM (non-volatile memory) Number of rewrites: 100,000
Ambient temperature : Operating: -10 to 55 ℃ (with no freezing or condensation)
Storage: -25 to 65 ℃ (with no freezing or condensation)
Ambient humidity : Operating: 25 to 85 %
Accessories : Waterproof packing, Fixtures, Terminal Cover, Unit label, Instruction manual, DeviceNet connector (made from Hirose), Crimp terminals (made from Hirose)
Weight : Approx. 300 g
Communications protocol : Conforms to DeviceNet
Remote IO communications : Master-Slave connection (Poll/Bit-Strobe/COS/Cyclic)
Conforms to DeviceNet communications standards.
IO allocations : Allocate any I/O data using the Configurator.
Allocate any datasuch as DeviceNet-specific parameters and variable area for Digital Indicators.
Input area: 2 blocks 60 words max.
Output area: 1 block 29 words max. (The first word in the area is always allocated for the Output Execution Enabled Flags.)
Message communications : Explicit message communications
CompoWay/F communications commands can be executed (using explicit message communications)
Connection forma : Combination of multi-drop and T-branch connectors (for trunk and drop line)
Communications media : Special 5-wire cable (2 signal lines, 2 power supply lines, 1 shield line)
Current consumption : 50 mA max. (24 VDC)
Maximum number of nodes : 64 (DeviceNet Configurator is counted as one node when connected)
Maximum number of slaves : 63
power supply : Supplied from DeviceNet communications connector
Power supply voltage : 24 VDC (11 to 25 VDC)


Chúng tôi có hơn 35.000 sản phẩm vì vậy hãy liên hệ với chúng tôi
Để được tư vấn và check tình trạng hàng bạn nhé!

AUTO TECH VN cam kết:
1. Hàng Chính Hãng Autonics Việt Nam.
2. Xuất được Hóa đơn VAT.
3. Cấp CO/CQ công chứng bởi Autonics Vina.
4. Giá cạnh tranh.
5. Sản phẩm bảo hành theo chính sách của hãng.

AUTO TECH VN - AUT.VN

Thông tin liên hệ

ĐT/ Zalo : 0968.053.025
Email: support@aut.vn Email2: sale@aut.vn
Địa chỉ: 07 KĐT Flora Mizuki, Đường Số 1, Bình Hưng, Bình Chánh, Hồ Chí Minh